Touch hole

Last updated

A diagram of the cannon, including the location of the touch hole Cannon-diagram2.svg
A diagram of the cannon, including the location of the touch hole
A sculpture in Whitehaven depicting an American sailor in the act of spiking a cannon 'Spiking The Guns' at Whitehaven. - panoramio.jpg
A sculpture in Whitehaven depicting an American sailor in the act of spiking a cannon

A touch hole, also known as a cannon vent, is a small hole at the rear (breech) portion of the barrel of a muzzleloading gun or cannon. The hole provides external access of an ignition spark into the breech chamber of the barrel (where the combustion of the propellant occurs), either with a slow match (matchlock), a linstock or a flash pan ignited by some type of pyrite- (wheellock) or flint-based gunlock (snaplock, snaphaunce, and flintlock), which will initiate the combustion of the main gunpowder charge. [1] Without touch hole, it would be nearly impossible to ignite the powder because the only otherwise access into the barrel is from the front via the muzzle, which is obturated by the projectile.

In the later caplock firearms, the ignition sparks are generated by a shock-sensitive percussion cap placed over a conical "nipple", which has a hollow conduit known as the flash channel, that leads into the barrel and serves the same function as the touch hole.

In modern breechloading firearms, the propellant charge is packaged inside a cartridge, which has a modified percussion cap (primer) seated in a cavity at the back end of the cartridge case. Between the primer pocket and the case chamber are one or more apertures known as flash holes, which serves functionally as a touch hole inside the cartridge.

In artillery, priming powder, a fuse, squib, or friction igniter is inserted into the touch hole to ensure ignition of the charge. The ignition might be achieved via striking or electrically.

Spiking the guns

Spiking a gun was a method of temporarily disabling a cannon by hammering a barbed steel spike into the touch hole; this could be removed only with great difficulty. If a special spike was unavailable, spiking could be done by driving a bayonet into the touch-hole and breaking it off, to leave the blade's tip embedded. [2] Guns could also be rendered useless by burning their wooden carriages or blowing off their trunnions. [3]

Count Friedrich Wilhelm von Bismarck, in his Lectures on the Tactics of Cavalry, recommended that every cavalry soldier carry the equipment needed to spike guns if an encounter with enemy artillery was expected. [4] If a cannon were in danger of being captured by the enemy, its crew would spike the gun to prevent it from being used against them. Captured guns would be spiked if they could not be hauled away and the gun's recapture seemed likely. Covert missions to spike the enemy's guns could also be done to prevent counterattacks and protect ships during withdrawal, as in the case of the Ranger's attack on Whitehaven during the American Revolutionary War.[ citation needed ]

Related Research Articles

<span class="mw-page-title-main">Firearm</span> Gun for an individual

A firearm is any type of gun that uses an explosive charge and is designed to be readily carried and used by an individual. The term is legally defined further in different countries.

<span class="mw-page-title-main">Percussion cap</span> Ignition source in a type of firearm mechanism

The percussion cap, percussion primer, or caplock, introduced in the early 1820s, is a type of single-use percussion ignition device for muzzle loader firearm locks enabling them to fire reliably in any weather condition. Its invention gave rise to the caplock mechanism or percussion lock system which used percussion caps struck by the hammer to set off the gunpowder charge in rifles and cap and ball firearms. Any firearm using a caplock mechanism is a percussion gun. Any long gun with a cap-lock mechanism and rifled barrel is a percussion rifle. Cap and ball describes cap-lock firearms discharging a single bore-diameter spherical bullet with each shot.

Tubes and primers are used to ignite the propellant in projectile weapons.

<span class="mw-page-title-main">Cartridge (firearms)</span> Pre-assembled firearm ammunition consisting of a casing, projectile, propellant, and primer

A cartridge, also known as a round, is a type of pre-assembled firearm ammunition packaging a projectile, a propellant substance and an ignition device (primer) within a metallic, paper, or plastic case that is precisely made to fit within the barrel chamber of a breechloading gun, for convenient transportation and handling during shooting. Although in popular usage the term "bullet" is often used to refer to a complete cartridge, the correct usage only refers to the projectile.

A muzzleloader is any firearm in which the user loads the projectile and the propellant charge into the muzzle end of the gun. This is distinct from the modern designs of breech-loading firearms, in which user loads the ammunition into the breech end of the barrel. The term "muzzleloader" applies to both rifled and smoothbore type muzzleloaders, and may also refer to the marksman who specializes in the shooting of such firearms. The firing methods, paraphernalia and mechanism further divide both categories as do caliber.

<span class="mw-page-title-main">Flintlock</span> Firearm with flint-striking ignition

Flintlock is a general term for any firearm that uses a flint-striking ignition mechanism, the first of which appeared in Western Europe in the early 16th century. The term may also apply to a particular form of the mechanism itself, also known as the true flintlock, that was introduced in the early 17th century, and gradually replaced earlier firearm-ignition technologies, such as the matchlock, the wheellock, and the earlier flintlock mechanisms such as the snaplock and snaphaunce.

<span class="mw-page-title-main">Centerfire ammunition</span> Type of ammunition that is commonly found in small-, medium-, and large-caliber firearms

A center-fire is a type of metallic cartridge used in firearms, where the primer is located at the center of the base of its casing. Unlike rimfire cartridges, the centerfire primer is typically a separate component seated into a recessed cavity in the case head and is replaceable by reloading the cartridge.

<span class="mw-page-title-main">Breechloader</span> Class of gun which is loaded from the breech

A breechloader is a firearm in which the user loads the ammunition from the breech end of the barrel, as opposed to a muzzleloader, in which the user loads the ammunition from the (muzzle) end of the barrel.

<span class="mw-page-title-main">Gun barrel</span> Firearm component which guides the projectile during acceleration

A gun barrel is a crucial part of gun-type weapons such as small firearms, artillery pieces, and air guns. It is the straight shooting tube, usually made of rigid high-strength metal, through which a contained rapid expansion of high-pressure gas(es) is used to propel a projectile out of the front end (muzzle) at a high velocity. The hollow interior of the barrel is called the bore, and the diameter of the bore is called its caliber, usually measured in inches or millimetres.

Internal ballistics, a subfield of ballistics, is the study of the propulsion of a projectile.

<span class="mw-page-title-main">Smokeless powder</span> Type of propellant

Smokeless powder is a type of propellant used in firearms and artillery that produces less smoke and less fouling when fired compared to black powder. Because of their similar use, both the original black powder formulation and the smokeless propellant which replaced it are commonly described as gunpowder. The combustion products of smokeless powder are mainly gaseous, compared to around 55% solid products for black powder. In addition, smokeless powder does not leave the thick, heavy fouling of hygroscopic material associated with black powder that causes rusting of the barrel.

<span class="mw-page-title-main">Dreyse needle gun</span> Prussian bolt-action rifle

The Dreyse needle-gun was a 19th-century military breech-loading rifle, as well as the first breech-loading rifle to use a bolt action to open and close the chamber. It was used as the main infantry weapon of the Prussians in the Wars of German Unification. It was invented in 1836 by the German gunsmith Johann Nikolaus von Dreyse (1787–1867), who had been conducting numerous design experiments since 1824.

<span class="mw-page-title-main">Lock (firearm)</span>

The lock of a firearm is the mechanism used to initiate firing. It is a historical term, in that it generally refers to such mechanisms used in muzzle-loading and early breech-loading firearms. Side-lock refers to the type of construction, in which the individual components of the mechanism are mounted either side of a single plate. The assembly is then mounted to the stock on the side of the firearm. In modern firearm designs, the mechanism to initiate firing is generally constructed within the frame or receiver of the firearm and is referred to as the firing or trigger mechanism.

<span class="mw-page-title-main">Flash pan</span> Firearm component

The flash pan or priming pan is a small receptacle for priming powder, found next to the touch hole on muzzle-loading guns. Flash pans are found on gonnes, matchlocks, wheellocks, snaplocks, snaphances, and flintlocks.

This article explains terms used for the British Armed Forces' ordnance (weapons) and ammunition. The terms may have different meanings depending on its usage in another country's military.

<span class="mw-page-title-main">Hammer (firearms)</span> Part of a firearm

The hammer is a part of a firearm that is used to strike the percussion cap/primer, or a separate firing pin, to ignite the propellant and fire the projectile. It is so called due to the fact that it resembles a hammer in both form and function. The hammer itself is a metal piece that forcefully rotates about a pivot point.

<span class="mw-page-title-main">Handgun</span> Short-barreled firearm designed to be held and used with one hand

A handgun is a firearm designed to be usable with only one hand. It is distinguished from a long gun which needs to be held by both hands and braced against the shoulder. Handguns have shorter effective ranges compared to long guns, and are much harder to shoot accurately. While most early handguns are single-shot pistols, the two most common types of handguns used in modern times are revolvers and semi-automatic pistols, although other handguns such as derringers and machine pistols also see infrequent usage.

The following are terms related to firearms and ammunition topics.

In firearms and artillery, the primer is the chemical and/or device responsible for initiating the propellant combustion that will propel the projectiles out of the gun barrel.

<span class="mw-page-title-main">Louis-Nicolas Flobert</span>

Louis-Nicolas Flobert (1819–1894) was a French inventor. He invented the first metallic rimfire cartridge in 1845. It was a major innovation in firearms ammunition technology, as it was previously delivered as separate bullets and gunpowder, pertaining to muzzle-loading firearms. The rimfire cartridge combined both elements in a single metallic cartridge containing a percussion cap, gunpowder, and a bullet, into a single weatherproofed package or container. Before that, a "cartridge" was simply a pre-measured quantity of gunpowder together with a ball (bullet), in a small cloth bag, which also acted as wadding for the powder charge and ball.

References

  1. Vauban and the French military under Louis XIV, Jean-Denis G. G. Lepage, p.38
  2. Richard M. Lytle (1 January 2004). The Soldiers of America's First Army, 1791. Scarecrow Press. p. 101. ISBN   978-0-8108-5011-8.
  3. Dewey Lambdin (1 April 2009). H. M. S. Cockerel. McBooks Press. pp. 279–. ISBN   978-1-59013-466-5.
  4. Bismarck, Friedrich Wilhelm (1855). On the Uses and Application of Cavalry in War. London: T and W Boone. p. viii. Retrieved 13 September 2012. translated by North Ludlow Beamish